Our community of experts have been thoroughly vetted for their expertise and.

Apr 25, enable stpd s2 ports 13[/code]If you remove the port from the Vlan the STP config disappears: Edge # configure vlan data_ delete ports 13[/code]Warning: STP port (13) is lost due to port is deleted from VLAN.[/code]Edge # show config include 13 configure vlan Voice_ add portstagged. Jul 07, Spanning tree blocks ports (resp.

VLANs on a port) inside the spanning tree domain only. You can create loops outside the STP domain that cannot be detected by the spanning tree protocol, e.g.

It would also be useful if it did it in an automated manner, as letting loose the configuration to someone who could not quite be familiar with STP but change port vlan regularly, the config could get out of sync.

by connecting to edge ports using a switch that drops the spanning tree BPDUs. Dec 04, If you created any additional VLANs, you could add those ports to the STP s0 domain using the following command: configure stpd add vlan ports [/code]The above command allows you to be specific about the ports you want to add.

If you do however wish to add all the ports, the auto-bind feature outlined in the article Dorian provided can be very. Feb 12, AM. AM. The command does not disable gresham tree removal permits tree on the port, but is does force the port into the Forwarding State, which is basically disabling STP. It is not truely disabling Spanning Tree all together, it is just disabling the other Spanning Tree shrubpruning.barted Reading Time: 5 mins.

Aug 12, I've set the spanning tree mode to MSTP and the ports have completely different VLANs. SW1 ports connects to port 43 on SW2, SW3, SW4, SW5 respectively - all are Trunking with VLAN SW2 port 44 connects to port 44 on SW4 - Trunking VLAN At this point STP kicks in and blocks the shrubpruning.barted Reading Time: 2 mins.